Additional Information ConcentrationVaried Storage ConditionAmbient (>5 °C) Safety Data SheetSDS Certificate of Analysis    Analytes Analyte CAS Number Target Concentration Benzene 71-43-2 4160 mg/100g Toluene 108-88-3 16410 mg/100g Ethylbenzene 100-41-4 4100 mg/100g m-Xylene 108-38-3 4910 mg/100g p-Xylene 106-42-3 4910 mg/100g o-Xylene 95-47-6 5000 mg/100g Isopropylbenzene 98-82-8 2450 mg/100g n-Propylbenzene 103-65-1 2450 mg/100g 1-Methyl-3-ethylbenzene 620-14-4 2450 mg/100g 1-Methyl-4-ethylbenzene 622-96-8 2440 mg/100g 1,3,5-Trimethylbenzene 108-67-8 2460 mg/100g 1-Methyl-2-ethylbenzene 611-14-3 2500 mg/100g 1,2,4-Trimethylbenzene 95-63-6 4140 mg/100g 1,2,3-Trimethylbenzene 526-73-8 2540 mg/100g Indan 496-11-7 2730 mg/100g 1,4-Diethylbenzene 105-05-5 2450 mg/100g n-Butylbenzene 104-51-8 2440 mg/100g o-Diethylbenzene 135-01-3 2500 mg/100g 1,2,4,5-Tetramethylbenzene 95-93-2 1680 mg/100g 1,2,3,5-Tetramethylbenzene 527-53-7 1680 mg/100g Naphthalene 91-20-3 1880 mg/100g 1-Methylnaphthalene 90-12-0 1880 mg/100g 2-Methylnaphthalene 91-57-6 1930 mg/100g Isooctane 540-84-1 19920 mg/100g Benzene-d6 1076-43-3 1980 mg/100g Ethylbenzene-d10 25837-05-2 1978 mg/100g Naphthalene-d8 1146-65-2 1042 mg/100g Properties Molecular FormulaN/A Molecular of WeightN/A Melting Point (°C)-95 Boiling Point (°C)111 Flash Point (°C)40F (tcc)    Safety Information Symbol Signal wordDanger Hazard statementsMay cause kidney, liver, and respiratory system damage. (Specific target organ toxicity - single exposure) Category 2 Harmful if inhaled. (Acute toxicity, inhalation, category 4) May be fatal if swallowed. (Acute toxicity, oral, category 2) Causes severe eye irritation. (Eye damage/irritation, category 2A) Fatal if swallowed. (Acute toxicity, oral, category 1) Fatal if inhaled. (Acute toxicity, inhalation, category 1) This product is or contains a component that is classified (ACGIH, IARC, NTP, OSHA) as a cancer hazard. (Carcinogenicity, category 1A) Precautionary statementsEye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338) Skin contact: Wash thoroughly with soap and water. Get medical attention if irritation develops or persists. (P352) Store in a tightly closed container. (P404) Do not get in eyes, on skin or clothing. (P262) Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264) Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.    Transport Information UN NumberUN1993 Class3 Packing GroupIII