FormatLyophilized in glycerolQuantity100 µlReconstitutionFor reconstitution add 95 µl of sterile water. Note that due to glycerol in buffer, the lyophilized product appears as a dense liquid rather than a powder. Allow the product several minutes to solubilize after adding water. Mix thoroughly but gently. Avoid vigorous vortexing, as buffer contains detergent. Upon reconstitution, this standard is ready-to-load and does not require any additions or heating. See additional Handling Instructions below. PsaC standard protein concentration: 0.10 pmol/µl.StorageStore lyophilized/reconstituted at -20°C; once reconstituted make aliquots to avoid repeated freeze-thaw cycles. Please, remember to spin tubes briefly prior to opening them to avoid any losses that might occur from lyophilized material adhering to the cap or sides of the tubes.Tested applicationsWestern blot (WB)Recommended dilutionPositive control: a 2 μL load per well is optimal for most chemiluminescent detection systems. Standard curve: 3 loads are recommended (eg. 0.5, 2 and 4μL). For most applications a sample load of 0.2 μg of chlorophyll will give a PsaC signal in this range. Exact loads can vary with the sensitivity of your system and the abundance of the target protein in your samples. Note: Optimal quantitation is achieved using moderate sample loads/well, generally 1 to 5 ug total protein. A trial experiment may be required i) to bring your sample load within the standard curve range and ii) to obtain a signal that is strong enough to reliably quantify but not so strong as to consume ECL reagents too quickly or saturate your detection system. These goals may achieved by adjusting both sample and standard loads.Expected | apparent MW11.5 kDa (larger than native protein due to the addition of His-tag). In most gels PsaC migrates between 9 and 14 kDa